zircon sand making machine
In a variety of igneous minerals as output; chemically stable zircon, which are often stored and drift sand, and as detritus and sedimentary rocks and sedimentary rocks occur, and the real value of mining zircon sand type zircon deposits. In alkaline and alkaline rocks can be enriched pegmatite mineralization, the origin of the famous southern Norway and Russia Urals. Zircon is also often enriched in placer. Important gem zircon produced in the world Laos, Cambodia, Myanmar, Thailand and other places. Alkaline basalts in eastern China have gem zircon. Zircon is a zirconium and hafnium extract the most important mineral raw materials, but also for the defense and aerospace industries.
Zircon sand making machine also known as the crusher, the machine is widely used, not only to the hard, extremely hard materials, such as: zircon, granite, basalt, limestone, quartzite, gneiss, cement clinker, concrete aggregate, ceramic materials, iron ore, gold, copper, alumina, bauxite, silica, etc. More can be applied to the material properties vary greatly in artificial sand, pre-grinding cement, mining, refractories and other industries crushing super-crushing operation.
1. Open the door shut observed regularly observed inside the crusher wear, center feed tube, cone hat, the impeller, indecent Road liner, circular shield, the degree of wear wearable pieces of worn should be replaced or repaired, the replacement of wear-resistant Meanwhile blocks should be replaced to ensure the same weight wearable pieces.
Crusher work process open the door to observe the inner workings of observation is strictly prohibited, to avoid danger. Timely replacement of worn impeller body found find manufacturers repair. Special attention, without the consent of the manufacturer is prohibited without permission homemade impeller.
2. Zircon sand making machine every 400 hours of adding the right amount of grease, working 2000 hours open spindle bearing assembly for cleaning, general work 7200 hours, replace bearings. Upper bearing spindle assembly is swimming side, the lower end bearing is fixed, pulled by hand after assembly pulley should be flexible rotation.
3. Triangle belt tensioning drive size should be adjusted appropriately to ensure that the triangle belt force uniform, dual-motor drive, the tape should be grouped on both sides of the triangle matching, each group has its length as consistent as possible. Should be adjusted so that the difference does not exceed two motor current 15A.
4. In zircon sand making machine operation, because the device is a high-speed device, you should pay special attention to production safety. Relevant personnel should stay away from equipment, machine repair on To be conducted after the shutdown.